Tools (11): desoldering station Yihua 938

Page créée le 27/08/2025.

Desoldering station for SMDs

After seeing a review of a similar but much more expensive station on the Cyrob YouTube channel, I thought that if I could find an affordable one, it would be useful for desoldering SMDs.

The solutions I had been using until now were as follows:

I found the Yihua 938 station, which is reasonably priced, so reasonably priced that one wonders if it will do the job properly.

Package contents

Note: the rather thin cardboard box was badly damaged during transport. It is barely large enough to hold everything, so it will be difficult to store the equipment after use.

The station consists of:

It comes with two spare tips, some lead solder, a cleaning pot, anti-static angled tweezers and a specific stand.

Overview

Clamp and control box

Some characteristics

Cable lengths:

These cables cannot be disconnected.

The soldering tips are properly earthed. The resistance between each tip and the earth contact of the mains socket is approximately 0.3 Ω.

First test

The test is carried out on an old VB2N Vitrains PCB, which includes cylindrical melf cases and rectangular cases of various sizes. It works correctly. On very flat cases, the blades tend to slip, so they should not be tightened at all, but simply placed on either side.

Temperature accuracy

The test is carried out by melting tin-lead alloy on the tips to improve thermal contact. The sensing end of the thermocouple is clamped between the two tips by adjusting the spacing screw.

When the set point is changed with the adjustment knob, the displayed temperature rises or falls very quickly. In reality, the temperature rise at the tips is much slower due to thermal inertia. I wait about one minute after each change in setting to allow the temperature to stabilise.

Temperature test

Results (all values in °C)

Display (set point) 200 250 300 350 400 450 480
Actual temperature 245 284 325 360 405 439 460
Delta +45 +34 +25 +10 +5 −11 −20

We can see that the temperature is excessive at low values, roughly correct at around 400 °C, and then insufficient above. No calibration is planned.

For desoldering SMDs, it is advisable to set the temperature to a maximum of 200 to 220 °C, so as not to exceed 250 °C in reality. However, bear in mind that the results obtained are only valid for my particular model.

Conclusion

This tool can be useful if you have a lot of CMS components to desolder. However, it is only suitable for components with two contacts. I do not think it can be used to desolder integrated circuit packages, for which hot air is probably still the best option.

Yihua 938 station
Price 2025: around €28
at AliExpress.