Improving the Roco “Bruhat” coach (2)

Page created on 04/11/2024; updated on 07/11/2024.

Lighting

Fitting the bogies

As is often the case, the current pickup is provided by thin ⌀ 0.15 wires wound around the axle shafts. You can also see the entry of the strip power supply wire in the toilets, near the drain pipe of the these.

Current pickup on the axles

The wound wires are soldered to small pieces of self-adhesive copper. There aren’t many empty places on the beautiful REE bogies…

Soldering the wires on copper surfaces

Lighting strip

The lighting strip uses a voltage multiplier. It’s easy to fit, with just the need to cut the injection pin under the roof, in the middle, and the passage for the capacitors in the toilets.

I glued 1.5 mm thick polystyrene supports (blue) to the crosspieces to support the strip.

General view of the strip (back)

Close-up: you can see the cut-out above the toilet to put a capacitor in it. The distance between the capacitor (100 µF / 25 V) and the board can be up to 20 mm.

Close-up view of the strip (back)

The strip is glued with thin double-sided tape.

General view of the strip (front)

The length of the capacitor wires allows the light to be clearly visible through the toilet window.

Close-up view of the strip (front)

The illuminated coach, seen at night.

The illuminated coach, seen at night