Original page created on 18/10/2022.
These strips replace the ones I had etched at home. They are equipped with a voltage multiplier circuit, like most of those made recently.
To avoid multiplying the references and thus the price, I designed only two different models: the first one fits the A3B3D, the second one fits all the others, at the cost of mounting or not, some or different components, the most visible being the capacitors.
Here we see the same strip mounted for a B9, then for an A8.


Here is a picture of three coaches: from back to front, an A3B3D, a B9 and an A8. On the latter, the resistor R51 is mounted (arrow), which is not the case for the B9.

Browse the photo to see the details.
I took advantage of the installation of these strips to remake the bogie wiring, whose wires were soldered on not so unobtrusive printed circuit boards (see page 4). They are now connected to self-adhesive copper pieces above the bogies.

The A3B3D has one large lamp at the bottom and two small at the top. Only the big one will be equipped. Strangely enough, LS Models has fitted it with a square tenon. The vision of a square of light in a round lamp is not very pleasant… Therefore, we must first extract the transparent part, which is done by pushing firmly from the inside of the coach, then re-drill the opening to the diameter 2 mm.

We also have to make a small cut behind the lantern (yellow dashes) to leave room for the future PCB.

Below is a view from the inside. The hole for the lamp is marked by the yellow arrow. Two things can be noticed:

On this picture, you can see that the end glazing has been glued, even though it was not necessary, given the design of this part which automatically locks onto the side glazing…
I prepare a “universal” lamp circuit which I have to reduce by 0.5 mm in width, and cut about half horizontally so that it can pass under the window pane.
A small black plastic spacer, drilled to ⌀ 2, is glued under the glazing, coinciding with the lamp hole. Its function is to equalize the bearing surface of the circuit. The PCB is glued on top. For centring, I power the circuit so that I can see the light through the hole.

Checking the LED centring. It’s roughly right.

The wires are fixed with a little Blu-tack, one in the corner, the other between the window and the gangway. At the LED, the circuit is painted in No. 33 black Humbrol acrylic…

… then the wires and the Blu-tack are painted the same way.

The transparent part is put back in place with a little Kristal Klear. All that remains is to connect the wires to the strip and put the roof back on.

