Page created on 16/06/2025; updated on 15/08/2025.

Brand - Reference

L’Obsidienne 14003

Type

Richier VR 12 H road roller.

Comment

Kit consisting of resin parts (body and wheels), white metal parts (roof, front wheel support, etc.) and photo-etched parts. The moulding of the body is very fine, particularly the grilles on the bonnet; however, there are some minor deformations and the geometry could be better, not to mention micro-bubbles here and there.

As with any kit of this type, careful deburring is necessary, and some parts (wheels) may even need to be rectified. The various axles also need to be drilled. The white metal roof is quite flattened, but fortunately ductile enough to be straightened without difficulty… and without breaking.

The instructions are brief, so we will need to refer to as many photos as possible. I have compiled a collection of these. See the Documents section below.

The construction is not as easy as it seems, as the parts require a lot of adjustments. It was also necessary to create new parts to achieve a satisfactory result.

This model reminds us of the Dinky Toys model from the late 1950s!

Dinky Toys Richier road roller

Construction and modifications

See the article on the construction of the roller.

History

There is little information available about this machine. There is not even a Wikipedia article about the Richier company!

The VR 12 H was produced from 1957 (end date unknown), with approximately 5,000 units manufactured. It was equipped with a Baudouin two-cylinder diesel engine. It was started using compressed air contained in a tank visible on the right side.

Quote from Charge utile. Source.

This machine is powered by a Baudouin DK 2 two-cylinder engine with 31 DIN horsepower and compressed air start-up, followed by a manual gearbox allowing speeds of 1.7 to 6.3 km/h. It weighs 10 tonnes without ballast and can reach 14 tonnes with ballast. The working width is 1.95 m. The VR 12 H replaced the VR 12 G in 1957. More than 5,000 units were manufactured.

Documents :

Richier VR 12 H road rollerRichier VR 12 H road roller

Richier VR 12 H road roller at Egletons

Photo stal19.skyrock.com (broken link).

Richier VR 12 H road rollerRichier VR 12 H road roller

Dimension Actual 1:87 Model
Length ? ? 55.4
Width 1 950 22.4 24.46
Height ? ? 30.0
Wheelbase 2 700 1 31.0 38.5
Front wheel diameter 1 040 1 12.0 12.0
Front wheel width 1 110 1 12.8 14.0
Rear wheel diameter 1 300 1 14.9 15.0
Rear wheel width 480 1 5.5 6.0
  1. Uncertain values.